Reversing The Cable-Management Arm Installation; Figure 1-13. Reversing The Cable-Management Arm - Dell PowerEdge 6400 Installation Manual

05KCEeb1.fm Page 17 Thursday, September 14, 2000 1:37 PM
5HY  ),/( /2&$7,21 5 ? ??0XOWL?9?.&(HEIP
support.dell.com

Reversing the Cable-Management Arm Installation

1. Turn the cable-management arm over (see Figure 1-13).
pull pin
offset
hinge
rail-mounting
plate

Figure 1-13. Reversing the Cable-Management Arm

2. Remove the pull pins from the offset hinge of the cable-management arm.
3. Remove the rail-mounting plate.
NOTE: Make note of the orientation of the rail-mounting plate to the vertical rail.
4. Pull the hinge away from the cable-management arm assembly.
5. Position the offset hinge next to the cable-management arm assembly.
6. Replace the pull pin with the ring facing up.
7. Replace the rail-mounting plate in the same orientation to the opposite vertical
rail.
8. Replace the second pull pin with the ring facing up.
9. Perform the steps to install the cable-management arm. The opposite vertical rail
and the slotted pocket on the opposite side of the cable tray are used for reverse
the installation of the cable-management arm.
'(// &21),'(17,$/  3UHOLPLQDU\
latch pin

Rack Installation Guide 1-17