Figure 1-5. Removing The 24-U Rack Doors - Dell PowerEdge 6400 Installation Manual

05KCEeb1.fm Page 7 Thursday, September 14, 2000 1:37 PM
5HY  ),/( /2&$7,21 5 ? ??0XOWL?9?.&(HEIP
support.dell.com
hinge insert

Figure 1-5. Removing the 24-U Rack Doors

CAUTION: Store the two doors where they will not injure someone if the
doors accidently fall over.
If you want to reverse the door so that the handle is on the other side, perform the
following steps:
1. With the door open, lift out and fully retract all hinge pins.
2. Remove the hinges and door brackets from the door frame.
3. Replace the hinges and door brackets on the opposite side and switch the posi-
tion of the handle.
4. Replace the rack door (see the section, "Replacing the Rack Doors", found later
in this guide).
'(// &21),'(17,$/  3UHOLPLQDU\
hinge pin
hinge

Rack Installation Guide 1-7