Notes On The Processing And Production Of Plate Blanks - Brother BAS-341F Instruction Manual

14.NOTES ON THE PROCESSING AND PRODUCTION OF PLATE BLANKS

14. NOTES ON THE PROCESSING AND
PRODUCTION OF PLATE BLANKS
* Chamfer other corners of the reverse side of the plate blank with a thickness of C0.3 or thicker, and finish the corners
with fine sand paper.
Please carry out the following points to chamfer the reverse side of the plate blank when using the plate blank for any
supplementary processing of material.
*Cross-section A-A'
53
Plate blank
After processing
Use fine sand paper
or similar material
to acquire a smooth
surface for this section.
1969S
BAS-341F, 342F
Plate blank
After processing
Point at which to use
sand paper, etc.
1970S
1968S