3. PREPARATION
3-4. Connecting the ground wire
Be sure to connect the ground. If the ground connection is not secure, you run the risk of receiving a serious
electric shock.
3-5. V-belt tension
3-6. Installing the foot switch
5
3-phase
Red
power supply
White
Black
Yellow/Green
Connect to
Yellow/Greeen
ground
CAUTION
Connection method for 3-phase power supply.
0064Q
These should approximately 10 - 12 mm of slack when V-
belt is loaded at 9.8 N . To adjust, loosen the two nuts (1),
and shift the motor up or down.
1923S
Insert the connector of the foot switch (2) into the
connector (3) of the control box (1).
1924S
BAS-341F, 342F