Table of Contents
Advertisement
—— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
h
Insert the bobbin case so that the
the bobbin case aligns with the
machine as shown below.
• Align the
a
mark
b
mark
c Bobbin case
• Make sure that the indicated points are
aligned before installing the bobbin case.
CAUTION
● Never use a bobbin case that is scratched,
otherwise the upper thread may become
tangled, the needle may break or sewing
performance may suffer. For a new bobbin
case (part code: XE7560-001), contact your
nearest authorized service center.
● Be sure that the bobbin case is correctly
installed, otherwise the needle may break.
mark on
mark on
and
marks.
i
Insert the tabs on the needle plate cover into the
needle plate, and then slide the cover back on.
a Needle plate cover
j
Install the flat bed attachment in its original
position.
Removing the needle plate
When the thread is tangled and cannot be removed
by cleaning the race, remove the needle plate.
a
a
Follow steps
through
b
Remove the needle plate by removing the
screws with the included screwdriver.
c
Remove the tangled thread from the needle
plate.
d
Return the needle plate to its original position, and
then tighten the screws with the included screwdriver.
Note
Align the two screw holes on the needle
plate with the two holes on the machine.
g
e
Follow steps
through
Care and Maintenance 127
a
f
on page 126.
j
(page 126-127).
4
Advertisement
Table of Contents
