RCA RCRPS04GZ Quick Start Manual

RCRPS04GZ
Quick Start Guide
Programming the Remote
Remove the battery compartment
1
cover, insert 2 AAA batteries (not
included), and replace the cover.
Press and hold the device key. Then
4
press the POWER key at the same
time. Wait until the POWER key
illuminates, then release both keys.
7 Test all of the following
keys that have a
function with this
component: POWER,
VOL+, CHAN+, 0, PLAY,
and STOP.
Programming Your Preset Channels
You can program up to 10 of your favorite channels on both
1
of your components for instant access using the Channel
Preset keys. First, put info for your favorite channels in the
following tables.
Channel
TV
Key
Name Number
Preset
P1
Channels
P2
P3
P4
P5
P6
P7
P8
P9
P0
4
6
When you've finished entering the
channel number, press the P key to
save it.
Accessing Your Preset Channels
Press the device
1
key (TV or
SAT•CBL•STREAM)
for the preset
channel.
See the Owner's Manual for more info and troubleshooting.
For additional support, call 1-800-420-7968 or visit RCAAudioVideo.com
2
Manually turn on the device you
want to control.
Enter the numbers for your brand
5
from the Brand Code List.
VOLUME
Channel
SAT•
Key
CBL•
Name Number
STREAM
Preset P1
Channels
P2
P3
P4
P5
P6
P7
P8
P9
P0
Press the device
key for this preset
channels list.
Press the P key.
2
The POWER key
lights up and
stays lit.
3
6
1x
8
CH+ 0–
2
3
5
To program more presets:
Repeat steps 2–6 for the next channel in your list.
To start using your presets:
See Accessing Your Preset Channels below.
3
Find the device's brand in the
Brand Code List. Circle it and keep
the list handy.
Note: If your brand
isn't in this list, see the
Owner's Manual for
other ways to program.
Point the remote directly at your
component and press GUIDE•HOME.
If your device turns off, go to the
next step. If not, repeat this one.
OFF
2s . . . 2s
NEXT STEP
1x
If these keys work, press
OK•ENTER to store the code.
To program the other
device keys, follow
these instructions
again.
Press and hold the
P key. The POWER
key illuminates.
Keep holding the P
key down until the
POWER key blinks
once and stays on.
Then release it.
Press the key to
program your first
preset channel.
Enter the channel
number for your
first preset channel
from the table you
filled out in step 1.
Press the
number for
the preset
you want to
access.
While POWER is lit, just press the
number to go to a preset.