RCA RCRPS04GR Owner's Manual page 18

Advanced Punch-Through
Volume punch-through as described above occurs
automatically. Advanced punch-through lets you
specify one device for all volume commands
for each non-audio mode (SAT•CBL•STREAM,
AUDIO•AUX if programmed for a non-audio device,
or DVD•VCR). You can specify either the TV or
AUDIO device.
1. Press and hold the device key whose volume
commands you want to send to the TV or
audio device. The POWER key turns on.
2. While holding down the device key, press and
hold the VOL + key. The POWER key turns off.
3. After holding down both keys for 3 seconds,
the POWER key turns on and stays on. Release
both keys.
4. Press the device key you want the Volume
Punch-Through to be directed to from the
selected mode (TV or AUDIO•AUX key). The
POWER key fl ashes.
Note: The device key pressed in step 4 must be
programmed with a TV or AUDIO component. If an
invalid key is pressed, the POWER key fl ashes four
times, then turns off.
Important: Once you have programmed any
device with a specifi ed Volume Punch-Through,
the Volume Punch-Through for all other devices
defaults to AUDIO. If you do not want other
components' Volume Punch-Through to default to
AUDIO, you must manually program them, using
steps 1-4.
Resetting Volume Punch-Through
You can reset volume punch-through to its default
behavior (sending volume commands to either TV
or AUDIO•AUX, whichever was pressed last).
1. Press and hold the device key whose volume
punch-through functionality you want to reset
to the original behavior. The POWER key turns
on.
2. While holding down the device key, press and
hold the VOL – key. The POWER key turns off.
3. After holding down both keys for 3 seconds,
the POWER key turns on and stays on. Release
both keys. The POWER key fl ashes, and the
volume punch-through for this device is reset
to the original behavior.
To reset volume punch-through for other
devices, repeat the steps above for that device
key.
18