Learning - RCA RCRPS04GR Owner's Manual

Learning

Codes from the Code Lists include basic functionality
for each component they control. Once you
have programmed in the code for your specifi c
component, you can customize the universal remote
to include certain functions from your original
remote(s) that were not embedded in the preset
code. Your universal remote has the ability to learn
and store commands from your original remote(s)
under the mode(s) of your choice. The universal
remote can store up to 50 key commands.* Only one
original remote can be learned under any one mode
(e.g., the universal remote can learn commands for
one TV remote, one VCR remote, etc.).
* Some learned signals require more memory than
others. In these cases, fewer key commands can be
learned.
Before First-Time Learning
Before you start learning keys for the fi rst time, clear
any stored learning information that might be in the
remote. This lets you begin with a clean slate.
1. Press and hold the EXIT•BACK key (the POWER
key illuminates). While you're holding down
the EXIT•BACK key, use your other hand to
press and hold the POWER key (the POWER key
illumination turns off).
2. Wait until the POWER key comes on and stays
on. Then release both keys. The remote is now
in the Master Clear mode.
3. Press the OK / ENTER key to confi rm the Clear
operation. The POWER key remains on for 2
seconds, then turns off. All Learned functions
for all components are now cleared; all other
programming remains intact.
Learning From Your Original Remotes
1. Place your original remote and the learning
remote on a fl at surface as shown below. Point
the top of your original remote at the top of
the learning remote. The IR LED on the original
remote should be pointing directly at the learning
remote's learning sensor, located on the top of the
remote. The remotes should be 1–2 inches apart.
2. On the learning remote,
press and hold the device key
you want to use the learned
function in (the POWER key
turns on and remains on).
While holding down the
device key, use your other
hand to press and hold the
RECORD key (the POWER key
illumination turns off).
1–2"
21