If You Forget The Password; Entering The Password Recall Procedure; Changing The Password - BenQ W700 User Manual

If you forget the password

If the password function is activated, you will be asked
to enter the five-digit password every time you turn on
the projector. If you enter the wrong password, the
password error message as pictured to the right displays
lasting for three seconds, and the message 'INPUT
PASSWORD' follows. You can retry by entering
another five-digit password, or if you did not record the
password in this manual, and you absolutely do not remember it, you can use the password
recall procedure. See
If you enter an incorrect password 5 times in succession, the projector will automatically
shut down in a short time.

Entering the password recall procedure

1. Press and hold AUTO on the projector or remote
control for 3 seconds. The projector will display a
coded number on the screen.
2. Write down the number and turn off your
projector.
3. Seek help from the local BenQ service center to
decode the number. You may be required to
provide proof of purchase documentation to
verify that you are an authorized user of the
projector.

Changing the password

1. Open the OSD menu and go to the SYSTEM SETUP: Advanced > Security Settings >
Change password menu.
2. Press MODE/ENTER. The message 'INPUT CURRENT PASSWORD' displays.
3. Enter the old password.
• If the password is correct, another message 'INPUT NEW PASSWORD' displays.
• If the password is incorrect, the password error message displays lasting for three
seconds, and the message 'INPUT CURRENT PASSWORD' displays for your
retry. You can press MENU/EXIT to cancel the change or try another password.
4. Enter a new password.
The digits being input will display as asterisks on-screen. Write your selected password down
here in this manual in advance or right after the password is entered so that it is available to
you should you ever forget it.
Password: __ __ __ __ __
Keep this manual in a safe place.
5. Confirm the new password by re-entering the new password.
6. You have successfully assigned a new password to
the projector. Remember to enter the new
password next time the projector is started.
7. To leave the OSD menu, press MENU/EXIT.
"Entering the password recall procedure" on page 29
Password Error
Please Try again.
for details.
RECALL PASSWORD
Please write down the recall code, 
and contact BenQ 
Customer Center.
Recall code:
12345678
Password Changed
Operation
MENU Back
29