Table of Contents
Advertisement
6.
Appendix
6-1. Troubleshooting
Before asking for repair, please check your connection, settings and operation once again. If the trouble cannot be corrected,
please contact your dealer/distributor for instructions or repair.
6-1-1. Problems and where to check
Problem
The projector cannot be turned on.
The image cannot be projected.
The image is distorted.
The image is blurred.
Video image is disturbed
34
Check to see if the power plug is properly connected to the outlet.
Make certain that the main power switch is ON.
Check to see whether the panel key lock function is activated. If so, the main unit's control buttons
are locked and do not work, but the projector can be controlled using the remote control unit.
Is the temperature inside the projector too high? When the inside temperature is too high, the
protective function does not allow your projector to be turned on. Wait some time and then turn it on.
Check to see if the connected input has been selected.
Check to see if a cable is properly connected to the input terminal.
Check to see whether the douser is closed.
Check to see if the settings are all adjusted properly.
Check to see if the protractor is properly set up.
Make certain that the lens is properly focused.
Check to see if the screen and a projector are installed at correct angles.
The projection distance may be larger than the focusing range.
See if the lens and other parts have condensation on them. If the projector is turned on in a
warm place after storage in a cold place, the lens and other optical components inside may
develop condensation. In such a case, please wait several minutes until the comdensation
disappears.
Check whether the signal cable connected to the projector is disconnected.
Check these items
Advertisement
Table of Contents
