Names On The Remote Control - NEC NC1500C User Manual

1. What's in the Box? and the Names of the Projector Parts

1-4. Names on the Remote Control

-
6. AMPLITUDE / G button
Press the AMPLITUDE (G) button while depressing the CTL button, then the green (G signal) of the test pattern will be
turned off temporarily.
Press this button again while depressing the CTL button, and the green (G signal) will be projected again.
7. ENTRYLIST / B button
Press the ENTRYLIST (B) button while depressing the CTL button, then the blue (B signal) of the test pattern will be turned
off temporarily.
Press this button again while depressing the CTL button, and the blue (B signal) will be projected again.
8. POSI / LENS button
Press the POSI/LENS button while depressing the CTL button, to adjust the position of projected screen (Lens Shift Mode).
(See page 20)
9. PICT / SHUT button
• Press this button to turn off image projection temporarily. Press it again, and the image will be projected again.
• Press the PICT / SHUT button while depressing the CTL button, then the douser sill operate to shut off the light for
projection. The POWER indicator blinks in green while the douser is operating. Press this button again while depressing
the CTL button to cancel the operation of the douser.
NOTE
When GPIO Control is set to "Enable", it is not possible to turn the power on/off and the douser function.
10. MENU button
Operate this button, and menus for various settings and adjustments will be displayed on the LCD screen. (See page 24)
10
-
1. POWER ON button
Operate this button to turn on the power to your projector.
Press it three seconds or longer.
When turning on the power to your projector, first set the main
power switch to the main unit to ON, which puts your projector
on standby. (See page 17)
2. POWER OFF button
Operate this button to turn off (standby) the power to your
projector. Press it three seconds or longer.
3. Numeric buttons (1 to 0 buttons)
Use these buttons to enter alphanumeric characters. (See
page 26)
4. TEST button
• Press this button, and a test pattern will be displayed.
Check the test pattern on the LCD screen by pressing the
SELECT / button, then press ENTER to set your
selection.
To cancel the test pattern display, reselect the signal to
project.
5. KEYSTONE / R button
Press the KEYSTONE(R) button while depressing the CTL
button, then the red (R signal) of the test pattern will be turned
off temporarily. Press this button again while depressing the
CTL button, and the red (R signal) will be projected again.