Kyocera FS-2100DN Management Manual page 15

Using a Web Browser to Manage the IB-51
Filter Setting
Cover Page
POP over SSL
4-15. Management/E-mail > SNMP > General
The SNMP protocol is used to transfer administrative information across a network. You can choose between SNMPv1/v2c or SNMPv3.
Utilities that use a management information base (MIB) may not operate if SNMPv3 is turned on. In this situation, turn SNMPv3
off and set SNMPv1/v2c to Onor Read Only.
Item
SNMPv3
User Name
Authentication Protocol
Encryption
Authentication Password
Privacy Password
SNMPv1/v2c
Read Community
file:///C:/Tom/PDF/IB-51/IB-51%20Setup%20Guide%20HTML%20English/card_homepa...
You can designate strings to filter messages (up to 255 characters). Create filter strings using the
following prefixes.
S: Filter by Subject
—
T: Filter by To
—
C: Filter by Cc
—
F: Filter by From
—
To filter by any of several conditions (OR), separate strings with "|". To filter by several conditions
(AND), all of which must be met, separate strings with "&". For example, to print only messages
with a subject of "Service" or "Technical", use "S:Service | S:Technical".
When you have set up printing from e-mail, designate whether or not to print the message body as
well. Choose On to add a cover page when printing messages. If there is text in the message
body, it will be printed as the cover page. Choose Off to print file attachments only. If there is no
file attachment, nothing is printed.
Allows the SSL encryption for mail sever communication. Select OFF when it is not used.
OFF
—
StartTLS
—
POP over SSL
—
To activate the configuration, the
—
Description
Enables (On) or disables (Off) SNMPv3. The SNMPv3 protocol provides security using DES
encryption and MD5/SHA authentication. When SNMPv3 is on, set SNMPv1/v2c to Read Only or
Off.
Enter the username used by SNMPv3. Maximum of 32 single-byte characters.
You can choose between MD5 and SHA1.
Select the encryption algorithm from the following choices. Select OFF when it is not used.
OFF
—
DES
—
AES
—
To activate the configuration, the
—
Enter the password for authentication. Maximum of 40 single-byte characters.
Enter the password for encryption. Maximum of 32 single-byte characters.
SNMPv1/v2c can be set to enabled (On), Read Only, or disabled (Off). Turn SNMPv3 off if this
setting is set to On.
This is used to read device information. The default read community string is public. The correct
read community needs to be entered for an administration utility to send an SNMP request to read
a value, otherwise the IB-51 will reject the request.
Encryption needs to be set to ON.
Encryption needs to be set to ON.
Page 15 of 22
10/2/2012