Pioneer PDP-5020FD - 1080p KURO Plasma HDTV Operating Instructions Manual page 23

Install Your Flat Panel TV
Once your flat panel TV is mounted on the wall or suspended from the ceiling, follow the steps below to attach
the speaker.
1 ) Confirm that the speaker brackets are ready to support the speaker.
It is possible to jar the brackets out of alignment while installing the panel.
2 ) Connect the loose ends of the speaker cables to the speaker.
If the cables were bundled with rubber bands during installation, remove them before continuing.
3 ) Align the speaker with the brackets.
It is very easy to mount the speaker upside-down so confirm that the speaker is aligned properly before
continuing.
4 ) Insert the speaker brackets into the grooves at the rear of the speaker.
If the speaker fails to attach easily, adjust the angle of the brackets
•Insert the speaker from the bottom in an angle.
•Straighten it when it touches the speaker
bracket.
Note: Reverse procedure to remove the speaker.
5 ) Tighten the center screw then the side screws in the order shown above.
When installing the panel on a wall or ceiling, use the bottom screw holes on each speaker bracket.
Note: If the speaker needs to be repositioned (horizontally) after it is attached, loosen the speaker mounting
screws first. Adjust the position then retighten the screws.
Speaker
mounting
screw
(M5 x 10 mm)
Do NOT use these holes when
mounting on a wall or ceiling
➂
➀
Speaker
mounting screw
(M5 x 10 mm)
02
➁
Speaker
mounting
screw (M5 x 10 mm)
23
En