Door Reversibility - Whirlpool AZB 7570 Instructions For Use Manual

DOOR REVERSIBILITY

For your convenience:
In case you want to stack the dryer on a washing machine, you can
reverse the door opening direction, to lower the position of the door
handle.
Unplug the dryer.
A. Open the door.
B. Using a spanner, turn the contact pin (B) in the top part of the door
through 90° and pull it out.
C. Remove the door lock:
Unscrew the 2 screws above and below the door lock system.
D. Press the small knob above the door lock system with a small
screwdriver, move the door lock slightly upwards and pull the door lock
towards you with your finger.
E. Reverse the door:
Remove the two screws of the door fixing plate. Fasten the door again
on the desired side with the 2 screws. Take care to tighten the screws
horizontally to avoid pinching off the door seal.
Reposition the door lock:
Insert the door lock on the opposite side of the door fixing plate. Press
it fully into the hole and move it downward slightly, until the small knob
of the door lock system latches in position. Fasten the two screws
above and below the door lock system.
Now reinsert the contact pin on the inside of the door, at the top, by
inserting it and turning it again through 90°.
NOTE: Ideally you should use a Torx T20 type screwdriver to undo
and tighten the screws.
A
B
C
D
E
11