Whirlpool AZB 7570 Instructions For Use Manual page 6

Packaging
• The packaging box is 100% recyclable, as confirmed
by the recycling symbol.
Disposing of packaging and old appliances
• The dryer is built from reusable materials. The dryer
must be disposed of in compliance with local waste
disposal regulations.
• Before scrapping cut off the power cable so that the
dryer cannot be connected to the mains.
• The symbol on the product or on the
documents accompanying the product indicates that
this appliance must not be treated as household
waste. Instead it should be handed over to the
applicable collection point for the recycling of
electrical and electronic equipment. Disposal must
be carried out in accordance with local
environmental regulations for waste disposal.
• For more detailed information about treatment,
recovery and recycling of this product please contact
your local city council office, your household waste
disposal service or the shop where you purchased
the product.
Energy saving tips
• Always dry a full load, depending on the type of
laundry and the programme/drying time. For more
detailed information, see the programme chart.
• By preference use the maximum spin speed allowed by
your washing machine, since draining the water
mechanically requires less energy. You will save time
and energy when running your drying cycle.
• Do not overdry the laundry.
• Clean the lint filter after every drying cycle.
• Clean the heat exchanger every month.
• Place your dryer in a room with a temperature
between 15°C and 20°C. If the temperature is higher
then ventilate the room, e.g. by opening the window.
• Always select the correct programme/drying time for
the load in order to obtain the desired drying results.
• Select the 'Gentle' option only in case of drying small
loads.
• When drying cotton, for example, dry Iron Dry and
Cupboard Dry loads together. Start with the Iron Dry
programme/drying time setting, remove the laundry to
be ironed at the end of that cycle and dry the remainder
of the load on the Cupboard Dry setting.
6
• Always set the program selector knob to the "0"
position after the end of the cycle.