Installation Procedures; Ccu Installation - Garmin GHP 20 Marine Autopilot System with SmartPump Installation Instructions Manual

Steering cylinders
Port line
Shutoff valves
Return line
Pump
Shadow Drive
Starboard line
Helms
Uflex MasterDrive power unit
High pressure line - DO NOT CUT

Installation Procedures

After you have planned the autopilot installation on your boat
and satisfied all of the mounting and wiring considerations for
your particular installation, you can begin mounting and
connecting the components.

CCU Installation

To install the CCU, you must mount it to your boat
connect it to the pump (page
network (page 2), and connect it to the alarm
Installing the CCU Mounting Bracket
Before you can mount the CCU, you must select a mounting
location (page 1) and determine the correct mounting hardware
(page 1).
The CCU bracket has two portions, the mounting portion and
the securing portion.
1
Use the mounting portion of the CCU bracket as a mounting
template.
If you are installing the CCU on a vertical surface, install the
bracket with an opening at the bottom, so that the cables can
hang straight down and are not blocked by the mounting
hardware .
10
(page
11), connect it to a NMEA 2000
(page 11).
10),
2
Use a pencil to mark the pilot-hole locations at the mounting
location.
3
Drill the pilot holes.
4
Use screws
location.
Securing the CCU in the CCU Bracket
1
Connect the CCU cable and the NMEA 2000 drop cable to
the CCU.
2
Place the CCU in the CCU bracket with the wires
straight down .
to secure the CCU bracket to the mounting
hanging