Mobile Home Installation; Reversing Door Swing - Electrolux FGQ332ES Installation Instructions Manual

MOBILE HOME INSTALLATION
1. Dryer MUST be exhausted outside (outdoors, not beneath
the mobile home) using metal ducting that will not support
combustion. Metal ducting must be 4 inches (10.16 cm) in
diameter with no obstructions. Rigid metal duct is preferred.
2. If dryer is exhausted through the floor and area beneath
the mobile home is enclosed, the exhaust system MUST
terminate outside the enclosure with the termination
securely fastened to the mobile home structure.
3. When installing a gas dryer into a mobile home, a provision
must be made for outside make up air. This provision is to
be not less than twice the area of the dryer exhaust outlet.
4. This dryer MUST be fastened to the floor. Mobile Home
Installation Kit No. 169840 is available from your dealer.
5. Refer to pages 2 and 3 for other important venting
requirements.
6. Installation MUST conform to current Manufactured Home
Construction & Safety Standard (which is a Federal
Regulation Title 24 CFR-Part32-80) or when such standard
is not applicable, with American National Standard for
Mobile Homes. In Canada, the CSA Z240 is applicable.
The dryer is designed under ANSI Z 21.5.1 for
HOME USE only.
L
DON'T
©
_ _
Correct Incorrect
ii_i!;;i_ii_ii!i!iiii
iiiiiiiii
L
DO
i\ i
Correct U
Incorrect
REVERSING DOOR SWING
Your dryer is designed so the door swing may be reversed at
any time without additional parts. Conversion is accomplished
by transferring hinges to the opposite side of the cabinet.
To change the direction of the door opening:
,
Open the dryer door. Removethe four hinge hole plugs from
the left side of the door opening. Place nearby for future
installation. NOTE: You may need a plastic knife to help
pull out the plugs. Be careful not to scratch the paint.
,
Remove the four screws that secure the door hinges to the
dryer front panel (see below). NOTE: Remove one screw
from each of the two hinges first. Hold the door firmly before
removing the last two screws.
3. Rotate the door 180 ° and reinstall the door hinges to the
dryer front panel with the four screws.
f. Install the four hinge hole plugs in the open screw holes on
the right side of the door opening.
REMOVE 4 SCREWS
(ONE FROM EACH
HINGE FIRST)