Mobile Home Installation - Electrolux FEQ1442ES Installation Instructions Manual

MOBILE HOME INSTALLATION
1 Dryer MUST be exhausted outside (outdoors, not beneath the
mobile home) using metal ducting that will not support
combustion Metal ducting must be 4 inches (1016 cm) in
diameter with no obstructions Rigid metal duct is preferred
2 If dryer is exhausted through the floor and area beneath the
mobile home is enclosed, the exhaust system MUST
terminate outside the enclosure with the termination securely
fastened to the mobile home structure
3 When installing a gas dryer into a mobile home, a provision
must be made for outside make up air This provision is to be
not lessthan twice the area of the dryer exhaust outlet
4 This dryer MUST be fastened to the floon Mobile Home
Installation Kit No 346764 is available from your dealer
5 Refer to pages 2 and 3 for other important venting
requirements,
6 Installation MUST conform to current Manufactured Home
Construction & Safety Standard (which is a Federal Regulation
Title 24 CFR-Part 32-80) or when such standard is not
applicable, with American National Standard for Mobile
Homes,
The dryer is designed under ANSI Z 21_E1 or
ANSVUL2158 - CAN/CSA C222 (latest editions) for HOME USE
only_
Correct
1 Using the four shipping carton corner posts (two on each side),
carefully Jay the dryer on its left side and remove the foam
shipping base
To prevent damage, do not use the control panel
as a means to pick up or move the dryer
2 Return the dryer to an upright position
FOAM
SHIPPING
REVERSING DOOR SWING
Your dryer is designed so the door swing may be reversed at any
time without additional parts_ Conversion is accomplished by
transferring hinges to the opposite side of the cabinet
"Solid door "Reversal Instructions:
1 Open the dryer door Remove the four hinge hole plugs from
the left side of the door opening_ Place nearby for future
installation NOTE; You may need a plastic knife to help pull
out the plugs Be careful not to scratch the paint.
2 Remove the four screws that secure the door hinges to the
dryer front panel (see below) NOTEr Remove one screw from
each of the two hinges first Hold the door firmly before
removing the last two screws_
3 Rotate the door 180° and reinstall the door hinges to the dryer
front panel with the four screws
4 Install the four hinge hole plugs in the open screw holes on the
right side of the door opening
DON'T
©
Incorrect
\
REMOVE 4 SCREWS
(ONE FROMEACH
HINGEFIRST}