Menu Selection System; Menu Selection And Sequence - Kyocera FS-1050 - B/W Laser Printer Service Manual

2-3-2 Menu selection system

The MENU key on the operator panel allows you to use the menu selection system to set or change
the printer environment such as the paper source, emulation, etc. Settings can be made when Ready
is indicated on the printer message display. The printer obeys the most recently received printer
settings sent from the application software, or from the printer driver, which take priority over
operator panel settings.

(1) Menu selection and sequence

The following is the hierarchy diagram of the menu selection system of the printer.
Ready
PAR A4
MENU
Print
Menu Map
Print
Status Page
Inter face >
Parallel
>Parallel I/F
Nibble (high)
>Parallel I/F
Auto
>Parallel I/F
Normal
>Parallel I/F
High Speed
Inter face >
USB
Interface >
Serial
>Bau rate
9600
>Data Bits
8
>Stop Bits
1
>Parity
None
>Protocol
DTR (pos.)&XON
These items will not
show unless the printer
is installed with the
applicable option unit.
2-19
Interface >
Option
>NetWare
Off
>NetWare
On
>TCP/IP
Off
>TCP/IP
On
>Ether Talk
Off
>Opt. StatusPage
Off
Continued on next page.
>
>>NetWare Frame
Auto
>
>>DHCP
On
>>IP Address
000.000.000.000
>>Subnet Mask
000.000.000.000
>>Gateway
000.000.000.000
FS-1050