Replacing The Memory Card Reader - eMachines T3104 - 256 MB RAM User Manual

CHAPTER 13: Adding and Replacing Components

Replacing the memory card reader

Tips & Tricks
You need a Phillips screwdriver to add or
replace a CD or DVD drive.
Important
The color and shape of your replacement
component's front cover may vary from
your original component.
162
To replace the memory card reader:
Remove the side panel by following the instructions in
1
panel" on page 154.
Remove the front bezel by following the instructions in
2
front bezel" on page
board. There should be enough slack in the cables to allow you to lay the
bezel on its side in front of the case.
Remove the single screw holding the card reader in the drive bay.
3
Disconnect the card reader's USB cable from the system board.
4
156, but leave its wires connected to the system
www.emachines.com
"Removing the side
"Removing the
Screw