IBM 8485E2U Installation Manual page 36

To install a simple-swap hard disk drive, complete the following steps:
1. Read the safety information that begins on page v and "Installation guidelines"
2. Turn off the server and peripheral devices and disconnect all external cables
3. Unlock the side cover (the bezel will not disengage from the server if the cover
4. Remove the side cover and lower bezel (see "Removing the side cover" on
5. Touch the static-protective package that contains the drive to any unpainted
6. Align the drive assembly with the guide rails in the bay (the connector end of
7. Pull the loops of the drive assembly toward each other; then, carefully slide the
If you have other options to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 28.
22
xSeries 206m Types 8485 and 8490: Installation Guide
on page 7.
and power cords.
is locked).
page 10 and "Removing the two-piece bezel" on page 11).
metal surface on the server; then, remove the drive from the package and place
it on a static-protective surface.
the drive goes in first).
drive assembly into the drive bay until it stops and release the loops.
Note: Do not release the loops on the drive assembly until it is completely
seated.