Handling Static-Sensitive Devices - IBM 8485E2U Installation Manual

User manual
Table of Contents

Advertisement

Handling static-sensitive devices

Attention:
To avoid damage, keep static-sensitive devices in their static-protective packages
until you are ready to install them.
To reduce the possibility of electrostatic discharge, observe the following
precautions:
v Limit your movement. Movement can cause static electricity to build up around
v The use of a grounding system is recommended. For example, wear an
v Handle the device carefully, holding it by its edges or its frame.
v Do not touch solder joints, pins, or exposed circuitry.
v Do not leave the device where others can handle and damage it.
v While the device is still in its static-protective package, touch it to an unpainted
v Remove the device from its package and install it directly into the server without
v Take additional care when handling devices during cold weather. Heating reduces
Static electricity can damage the server and other electronic devices.
you.
electrostatic-discharge wrist strap, if one is available. Always use an
electrostatic-discharge wrist strap or other grounding system when working inside
the server with the power on.
metal surface on the outside of the server for at least 2 seconds. This drains
static electricity from the package and from your body.
setting down the device. If it is necessary to set down the device, put it back into
its static-protective package. Do not place the device on the server cover or on a
metal surface.
indoor humidity and increases static electricity.
Chapter 2. Installing options
9

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Xseries 206m84858490

Table of Contents