Chamberlain Elite RSL12V Installation Manual page 20

ADJUSTMENT
» LEARN LIMITS
DUAL GATE (RIGHT-SIDE PRIMARY OPERATOR)
1
Close the gate.
2
Press and release the LEARN LIMITS button. The SET OPEN LIMIT LED will blink.
PROGRAM OPEN
3
Press and hold the GATE 1 left button to move the right operator to the desired
OPEN position. When the gate is in the desired position, release the button.
NOTE: The GATE 1 right and left buttons can be used to jog the gate back and
forth as needed.
4
Press and hold the GATE 2 left button to move the left operator to the desired
OPEN position. When the gate is in the desired position, release the button.
NOTE: The GATE 2 right and left buttons can be used to jog the gate back and
forth as needed.
5
Press and release the LEARN LIMITS button. The control board will beep and the
SET CLOSE LIMITS LED will blink.
PROGRAM CLOSE
6
Press and hold the GATE 2 right button to move the left operator to the desired
CLOSED position. When the gate is in the desired position, release the button.
NOTE: The GATE 2 right and left buttons can be used to jog the gate back and
forth as needed.
7
Press and hold the GATE 1 right button to move the right operator to the
desired CLOSED position. When the gate is in the desired position, release the
button. NOTE: The GATE 1 right and left buttons can be used to jog the gate
back and forth as needed.
8
Press and release the LEARN LIMITS button. The control board will beep and the
SET CLOSE LIMITS LED will stop blinking.
Programming is now complete. If the SET OPEN LIMIT LED continues to blink, repeat
programming. If the problem continues, see below.
Test the limits by pressing the SINGLE BUTTON to open and close the gate.
IF THE LIMITS WILL NOT PROGRAM
1
Disconnect both operators by pressing the reset switch on each operator to
RESET/DISCONNECT.
2
Manually close each gate.
3
Remove the learn limit cover and move the learn limit nut to the center position
on both operators.
4
Press the reset switch to NORMAL OPERATION on both operators.
Program the limits again.
1
3
GATE 1 Left Button
DIAGNOSTIC
GATE 1
CLOS
4
GATE 2 Left Button
SET
LE
CLOSE
LIMITS
LIMIT
GATE 2
FORCE
5
LEARN LIMITS Button
SET
SET
CLOSE
OPEN
LIMIT LIMIT
6
GATE 2 Right Button
SET
LE
CLOSE
LIMITS
LIMIT
GATE 2
FORCE
7
GATE 1 Right Button
DIAGNOSTIC
GATE 1
SET
CLOSE
8
LEARN LIMITS Button
SET SET
CLOSE
OPEN
LIMIT
LIMIT
Learn Limit Switch
19
SET
OPEN N N CLOSE CLOSE
LIMIT
2
LEARN LIMITS Button
Learn Limit Cover
Learn Limit Nut
GATE GATE 1 A
SET SET
LEARN
LIMITS
LIMIT LIMIT
G GATE 2