Chamberlain Elite RSL12V Installation Manual page 17

ADJUSTMENT
» LEARN LIMITS
SINGLE GATE LEFT-HAND SIDE
1
Close the gate.
2
Press and release the LEARN LIMITS button. The SET OPEN LIMIT LED will blink.
PROGRAM OPEN
3
Press and hold the GATE 1 right button to move the gate to the desired OPEN
position. When the gate is in the desired position, release the button.
NOTE: The GATE 1 right and left buttons can be used to jog the gate back and
forth as needed.
4
When the gate is in the desired OPEN position, press and release the
LEARN LIMITS button. The control board will beep and the SET CLOSE LIMITS
LED will blink.
PROGRAM CLOSE
5
Press and hold the GATE 1 left button to move the gate to the desired CLOSED
position. When the gate is in the desired position, release the button.
NOTE: The GATE 1 right and left buttons can be used to jog the gate back and
forth as needed.
6
When gate is in the desired CLOSED position, press and release the
LEARN LIMITS button. The control board will beep and the SET CLOSE LIMITS
LED will stop blinking.
Programming is now complete. If the SET OPEN LIMIT LED continues to blink, repeat
programming. If the problem continues, see below.
Test the limits by pressing the SINGLE BUTTON to open and close the gate.
IF THE LIMITS WILL NOT PROGRAM
1
Disconnect the operator by pressing the reset switch to RESET/DISCONNECT.
2
Manually close the gate.
3
Remove the learn limit cover and move the learn limit nut to the center
position.
4
Press the reset switch to NORMAL OPERATION.
Program the limits again.
1
3
GATE 1 Right Button
DIAGNOSTIC
GATE 1
SET
CLOSE
4
LEARN LIMITS Button
SET
SET
CLOSE
OPEN
LIMIT
LIMIT
5
GATE 1 Left Button
DIAGNOSTIC
GATE 1
SET
CLOS
6
LEARN LIMITS Button
SET
OPEN
LIMIT
Learn Limit Switch
16
SET
OPEN N N CLOSE CLOSE
LIMIT
2
LEARN LIMITS Button
Learn Limit Cover
Learn Limit Nut
GATE GATE 1 A
SET SET
LEARN
LIMITS
LIMIT LIMIT
G GATE 2