Connecting To Video Imaging Device - Yamaha PDM-5520 User Manual

INSTALLATION INSTRUCTIONS (continued)
Read CAUTION: READ THIS BEFORE OPERATING YOUR UNIT. and PRECAUTIONS (
carefully to ensure maximum safety before proceeding to these steps:
• Choose a safe, level location to install the product.
• Install the monitor in a location with easy access to a power socket.
• Make sure that the power switch of this device is turned off.

Connecting to Video Imaging Device

(1) Make sure that the power switch of the monitor is turned off.
(2) Make sure that the power switch of the imaging device is turned off.
(3) Use a commercially available cable and connector to connect the signal input terminal on the rear panel of this
device and the signal output terminal of the imaging device.
20 18 16 14
21 19 17 15 13
VCR
Adaptor
S-video/Composite video
Do not connect both
plugs at the same time.
Use either of them.
Video disc player
DVI-STB and RGB component setup
Applicable video signals for each input terminal (See PRODUCT SPECIFICATIONS for details.
Terminal RCA/SCART
Signal CVBS S-video
‡
AV1
‡
AV2
‡ ‡
AV3
‡ ‡
AV4
RGB1
RGB2
12 10 8 6 4 2
11 9 7 5 3 1
VCR
SUB WOOFER
To Subwoofer
To component video equipment
Please use connection cable suitable
for the terminal form of video
equipment.
Component RGB PC
‡
‡ ‡
‡
‡
Speaker (R)
Ω
Power
cord
Use if the
video
[
An example of connecting video imaging device]
equipment
has an
S-video
input terminal.
• If video equipment with an S video output terminal is used,
connection with S video cable is recommended to provide finer
video quality. (If the S-video input terminal and the video input
terminal of AV3 connect to the monitor at the same time, S-video
input would govern.)
• If the OUTPUT (MONITOR) terminal is connected to an external
monitor with a 75 Ohm terminal, it is possible to view the same
image as on the monitor. But it is possible to monitor only the
composite video signal from AV1, AV2, AV3 or AV4 input that is
displayed on the screen at the time.
• If the adaptor (included) is applied to AV4 input as shown in the
drawing, it is impossible to receive RGB signal.
DVI D-sub
STB RGB Component
‡
‡ ‡
6
Monitor rear panel
Ω
DVD player Set-Top Box
Remarks
22
Refer to Setup Menu.
Refer to Setup Menu. 22
Refer to Setup Menu. 23
Refer to Setup Menu. 23
(‡ : available)
to )
9
Speaker (L)
)
24
13