Default Factory Settings - NETGEAR FWG114Pv2 - Wireless Firewall With USB Print Server Reference Manual
Wireless 802.11g firewall/print server
Hide thumbs
Also See for FWG114Pv2 - Wireless Firewall With USB Print Server:
- Specifications (2 pages) ,
- Installation manual (2 pages) ,
- Introduction manual (11 pages)
Table of Contents
Advertisement
Reference Manual for the ProSafe Wireless 802.11g Firewall/Print Server Model FWG114P v2
Default Factory Settings
The FWG114P v2 default factory settings shown below. You can restore these defaults with the
Factory Default Restore button on the rear panel as seen in the illustration
Panel" on page
2-9. After you install the FWG114P v2 Wireless Firewall/Print Server, use the
procedures below to customize any of the settings to better meet your networking needs.
SSID broadcast
Wireless Card Access List for
Access Point Connections
WEP Security
Authentication Type
4-6
FEATURE
DEFAULT FACTORY SETTINGS
SSID
NETGEAR
RF Channel
11 until the region is selected
Access Point
Enabled
Enabled
All wireless stations allowed
Disabled
Open System
201-10301-02, May 2005
"FWG114P v2 Rear
Wireless Configuration
Advertisement
Table of Contents
Troubleshooting
