Configure Traffic Shaping - NETGEAR GSM7252PS - ProSafe 52 Ports Gigabit Ethernet L2 Managed Stackable Switch Software Administration Manual

ProSafe 7000 Managed Switch Software Administration Manual, Release 8.0.3
Note: The Traffic Class value range is <0-6> instead of <0-7> because queue 7 is reserved in a
stacking build for stack control, and is therefore not configurable by the user.
Web Interface: Setting CoS Trust Mode of an Interface
To use the Web interface to set CoS trust mode of an interface, set Cos Trust Mode to dot1p of the interface
1/0/3:
1. From the main menu, select QoS > Advanced >CoS Configuration. A screen similar to the following
displays.
Figure 10-6
2. Under CoS Configuration, Select the Interface radio button.
3. Select 1/0/3 in the interface field.
4. Select trust dot1p in the Interface Trust Mode field.
5. Click the Apply to save the settings.

Configure Traffic Shaping

This section describes the Traffic Shaping feature.
Traffic shaping controls the amount and volume of traffic transmitted through a network. This has the effect
of smoothing temporary traffic bursts over time.
Use the traffic-shape command to enable traffic shaping by specifying the maximum transmission
bandwidth limit for all interfaces (Global Config) or for a single interface (Interface Config).
Class of Service (CoS) Queuing
v1.0, June 2010
10-9