Operation; Turning The Power On; Check The Status Of Each Channel; Other Operations - Denon 3012CI - Power Amplifier Owner's Manual

ENGLISH

Operation

ZONE operation mode indicators
ON/STANDBY
ZONE 5

Turning the Power On

ON/STANDBY
Press the button.
The power indicator fl ashes green and the power turns on.
b The signal input to each channel is output from the speaker
terminal of each channel.
b The setting status of each channel is indicated on the display.
SELECT/ENTER
b Turn the knob to change the channel displayed.
Output channel
CH 1&2 BUS L+R
BTL
OPERATION MODE
(No display when in "NORMAL MODE")
n To return to STANDBY
ON/STANDBY
Press the button again.
The power indicator lights red.
NOTE
• When the "POWER CONFIGURATION" is set to "MASTER
TRIGGER" , the device will automatically enter the standby status
when no trigger input is detected for a period of 10 minutes.
• When the "POWER CONFIGURATION" is set to "ON LINE" , send
a standby command to the ETHERNET terminal or the RS-232C
terminal of the POA-3012CI.
• Power continues to be supplied to some of the circuitry even when
the power is in the standby mode. When leaving home for long
periods of time or when traveling, unplug the power cord from the
power outlet.


Check the Status of Each Channel

1
Press the
b Zone status is indicated on the bottom line of the display.
SELECT/ENTER
b Turn the
SELECT/ENTER
Channel No. & INPUT Line
2
Press the
b System status is indicated on the bottom line of the display.
SELECT/ENTER
b Turn the
DISPLAY
u/RETURN
n To Return to the Regular Display
u/RETURN
Press the

Other Operations

Other Operations During Playback

Input terminal
n To Adjust the Volume
Refer to "VOLUME CONTROL " on the "Main Setup" menu
(vpage 13).
0.0dB
n To Switch Input Setting
Volume level
Refer to "INPUT SELECT" on the "Main Setup" menu (vpage
13).
n To Reduce the Low Frequency Volume
Refer to "LOW CUT FILTER" on the "Main Setup" menu (vpage
13).
DISPLAY
button.
knob to change the display as follows.
VOLUME CONTROL level
ZONE T.ON MODE LOW CUT FILTER
DISPLAY
button again.
knob to change the display as follows.
POWER CONFIG DIMMER
button until the display returns to normal.
Operating the POA-3012CI Using a
Browser (Web control)
This function lets you operate the POA-3012CI using Internet
Explorer.
1
Check the POA-3012CI's IP Address.
"Network Setup" – "Network Information" (vpage 15)
2
Input the POA-3012CI's IP Address in Internet
Explorer.
For example, if the IP address is "10.3.18.90" , enter
http://10.3.18.90.
3
If the top menu is displayed, click "Setup Menu".
Click
4
When the "Setup Menu" is displayed, click on the
menu you want to operate.
Click the menu
CHANNEL SETUP (vExample : 1)
SYSTEM SETUP (vExample : 2)
WARNING AND PROTECTION DATA
(vExample : 3)
AUDIO SIGNAL AND TRIGGER
INPUT (vExample : 4)
OPTION SETUP (vExample : 5)
Click "SAVE" when you want to save settings,
and click "LOAD" when you want to call settings
Becomes each operation screen