Table D-1
Specifications (continued)
Rated Input Current (maximum)
This system utilizes a passive power factor corrected power supply. The power factor correction is present in the 230V
1
operating mode only. This allows the system to pass the CE mark requirements for use in the countries of the European Union.
This supply requires the use of an input voltage range select switch.
Small Form Factor
Table D-2
Specifications
Desktop Dimensions
Height
Width
Depth
Approximate Weight
Temperature Range
Operating
Nonoperating
NOTE:
Operating temperature is derated 1.0° C per 300 m (1000 ft) to 3000 m (10,000 ft) above sea level; no direct
sustained sunlight. Maximum rate of change is 10° C/Hr. The upper limit may be limited by the type and number of
options installed.
Relative Humidity (noncondensing)
Operating
Nonoperating (38.7°C max wet bulb)
Maximum Altitude (unpressurized)
Operating
Nonoperating
Power Supply
Operating Voltage Range
Rated Voltage Range
Rated Line Frequency
Power Output
Rated Input Current (maximum)
This system utilizes an active power factor corrected power supply. This allows the system to pass the CE mark requirements
1
for use in the countries of the European Union. The active power factor corrected power supply also has the added benefit of
not requiring an input voltage range select switch.
1
1
1
8A @ 100 VAC
3.86 in
13.19 in
15.23 in
14.05 lb
50° to 95°F
-22° to 140°F
10-90%
5-95%
10,000 ft
30,000 ft
115V
90-140 VAC
100-127 VAC
50-60 Hz
250 W
7A @ 100 VAC
4A @ 200 VAC
9.8 cm
33.5 cm
38.7 cm
6.51 kg
10° to 35°C
-30° to 60°C
3048 m
9144 m
230V
180-264 VAC
200-240 VAC
50-60 Hz
3.5A @ 200 VAC
Small Form Factor 185