HP dx7500 - Microtower PC Service & Reference Manual page 120
Service reference guide: hp compaq dx7500 business pc
Hide thumbs
Also See for dx7500 - Microtower PC:
- Hardware reference manual (59 pages) ,
- Troubleshooting manual (53 pages) ,
- Utility manual (12 pages)
Table of Contents
Advertisement
9.
Push in the latch holding the drive cage upright (1) and lower the drive cage all the way down
(2).
Figure 8-21
10.
Connect the appropriate drive cables:
a.
If installing a diskette drive, connect the power and data cables to the rear of the drive and
connect the other end of the data cable to the connector on the system board labeled FLOPPY.
b.
If installing a media card reader, connect the USB cable from the media card reader to the
USB connector on the system board labeled F_USB2.
NOTE:
system board drive connectors.
11.
Replace the front bezel and access panel.
12.
Reconnect the power cord and turn on the computer.
13.
Lock any security devices that were disengaged when the access panel was removed.
110 Chapter 8 Removal and Replacement Procedures Small Form Factor (SFF) Chassis
Lowering the Drive Cage
Refer to
System Board Drive Connections on page 100
for an illustration of the
- Quick Links:
- Computer Setup-Boot
- Rom Flash
Hide quick links:
Advertisement
Table of Contents
