Turning On The Monitor; Selecting Video Input Connectors; Adjusting The Tilt - HP WH344AA User Manual

Turning on the Monitor

1. Press the power button on the computer to turn it on.
2. Press the power button on the front of the monitor to turn it on.
CAUTION:
screen for a prolonged period of time.* To avoid burn-in image damage on the monitor screen, you
should always activate a screen saver application or turn off the monitor when it is not in use for a
prolonged period of time. Image retention is a condition that may occur on all LCD screens. Monitors
with a "burned-in image" are not covered under HP warranty.
* A prolonged period of time is 12 consecutive hours of non-use.
When the monitor is powered on, a Monitor Status message is displayed for five seconds. The
message shows which input is the current active signal, the status of the auto-switch source setting
(On or Off), the default source signal, the current preset display resolution, and the recommended
preset display resolution.

Selecting Video Input Connectors

The input connectors are:
●
DisplayPort (digital)
● DVI-D connector (digital)
●
HDMI connector (digital) 2310e model
The monitor automatically scans the signal inputs for an active input and uses that input for the
display. If two inputs are active, the monitor will display the default input source. If the default source
is not an active input, then the monitor will display the other input if it is active. You can change the
default source in the OSD by pressing the front panel Menu button and selecting Source Control >
Default Source.

Adjusting The Tilt

For optimal viewing, adjust the screen tilt to your own preference, as follows:
1. Face the front of the monitor and hold the base so that you do not topple the monitor while
changing the tilt.
ENWW
Burn-in image damage may occur on monitors that display the same static image on
Turning on the Monitor 11