Turning On The Monitor - HP 27y User Manual

Turning on the monitor

1. Press the Power button on the computer to turn it on.
2. Press the Power button on the bottom of the monitor to turn it on.
CAUTION: Burn-in image damage may occur on monitors that display the same static image on the
screen for 12 or more consecutive hours of nonuse. To avoid burn-in image damage on the monitor
screen, you should always activate a screen saver application or turn off the monitor when it is not in
use for a prolonged period of time. Image retention is a condition that may occur on all LCD screens.
A burned-in image is not covered under the HP warranty.
NOTE: If pressing the Power button has no effect, the Power Button Lockout feature may be enabled.
To disable this feature, press and hold the monitor Power button for 10 seconds.
NOTE: You can disable the power LED in the OSD menu. Press the Menu button on the bottom of the
monitor, and then select Power Control > Power LED > Off.
When the monitor is powered on, a Monitor Status message is displayed for five seconds. The message
shows which input is the current active signal, the status of the auto-switch source setting (On or
Off; default setting is On), the current preset screen resolution, and the recommended preset screen
resolution.
The monitor automatically scans the signal inputs for an active input and uses that input for the screen.
8 1 Getting Started