Specifications - Oki ML3410 Handbook

Specifications

Specifications
Printhead: 9 pin
Print speed @ 10 cpi: HSD 550 cps Utility 417 cps NLQ 104 cps
Emulations: Epson FX/IBM ProPrinter, co-resident Pacemark/Microline, by means of optional chip
set
Interface: Parallel and RS232C serial, standard Optional Twin-Ax/Co-Ax (3rd partycall
1-800-OKIDATA for information) Graphics resolution: 1445216 dpi maximum
Fonts: NLQ: Courier, Gothic, Proportional Draft: Utility, High Speed Bar Code: UPC-A, UPC-E,
EAN 8, EAN 13, Code 3 of 9, Interleaved 2 of 5 Buffer size: 64K
Reliability: Mean Time Between Failures (MTBF) 8,000 hours at 25% duty cycle, 35% page
density Mean Time To Repair (MTTR) 15 minutes Printhead life 200 million characters average in
10 cpi utility mode
Paper Specifications: Weight 12 to 24 lb. Thickness Top feed: 0.36 mm (0.014 inches) maximum
Bottom feed: 0.50 mm (0.020 inches) maximum
Continuous forms: Types Interleaved: original plus 5 copies Carbonless: original plus 7 copies
Width 3.5 to 16.5 inches
Cut sheet multi-part forms: Original plus 3 copies (top edge must be glued tight)
Labels: Carrier width 3.5 to 16.5 inches wide Use bottom feed only.
Envelopes: Weight 24-lb. maximum Size Minimum 6.5 5 3.6 inches Maximum 9.5 5 4.1 inches
Feed: Single feed Continuous feed overlap type only
Card stock: 120-lb. maximum Use bottom feed only.
Transparencies: Use top feed only.
Dimensions: Width 25-1/4 inches (540 mm) Depth 19 inches (483 mm) Height 15 inches (203 mm)
Weight 63 lbs. (25.4 kg)
Environmental Requirements: Operating Temperature 50 to 104 degrees F (10 to 40 degrees C)
Storage Temperature 14 to 122 degrees F (-10 to +50 degrees C) Humidity 20 to 80% RH
Electrical Requirements: Voltage 120 volts, +5.5%/-15% 220/240 volts, ±10% Frequency 50/60
Hz, ±2 Hz Power Idling: 30 watts Operating: 75 watts
Specifications subject to change without notice
ML3410 ( 96-02-07 )