Dell
14
Rack Information
13B
14.1
Overview
88B
The ReadyRails™ sliding rail system for the R810 provides toolless support for racks with square or
unthreaded round mounting holes including all generations of Dell racks. The optional cable
management arm (CMA) can be mounted on either the left or right side of the sliding rails without
the use of tools for fast and easy deployment.
IMPORTANT NOTES:
U
The R810 is not compatible with any other Dell rails including previous generation rails, but it
does use the same rails as the R815 & R910.
The R810 supports sliding rails only. Static rails are not supported.
Threaded-hole racks require Dell's fixed shelf or adapter brackets available from
RackSolutions
U
The CMA is not supported on racks that are less than 1m in depth including Dell's 4200 & 2400
racks.
14.2
Rails
89B
The ReadyRails sliding rails for the R810 support toolless mounting in 19‖-wide, EIA-310-E compliant
square-hole and unthreaded round-hole racks and are available with or without the optional cable
management arm (CMA).
Figure 21. R810 ReadyRails Sliding Rails with Optional CMA
As noted below, the R810 rails do not support mounting in threaded hole or 2-post racks*.
Rail
Identifier
B2
Dell PowerEdge R810 Technical Guide
.
U
Mounting
Rail
Interface
Type
ReadyRails™
Sliding
Rack Types Supported
4-Post
Square
Round
Thread
X
√
√
2-Post
Flush
Center
X
X
51