Eagle FISHMARK 320 Installation And Operation Instructions Manual page 16

B. Two-piece bracket: Locate the four plastic ratchets in the trans-
ducer's hardware package. Press two ratchets into the sides of the plas-
tic bracket and two on either side of the transducer as shown in the fol-
lowing illustrations. Notice there are letters molded into each ratchet.
Place the ratchets into the bracket with the letter "A" aligned with the
alignment mark molded into the bracket. Place the ratchets onto the
transducer with the letter "A" aligned with the 12 o'clock position on
the transducer stem. These positions set the transducer's coarse angle
adjustment for a 14° transom. Most outboard and stern-drive tran-
soms have a 14° angle.
Alignment letters
Alignment
positions
Transducer
Transducer
bracket
Insert and align ratchets.
Transducer
Transducer bracket
Ratchet
Ratchet
Add ratchets to bracket and transducer.
12