Eagle FISHMARK 320 Installation And Operation Instructions Manual page 18

bracket holes with the letter "B" aligned with the bracket alignment
mark. Place them on the transducer aligned with the 12 o'clock posi-
tion on the transducer stem.
Reassemble the transducer and bracket and place them against the
transom. Again, check to see if you can move the transducer so it's
parallel with the ground. If you can, then go to step 3B. If it doesn't,
repeat step 2B, but use a different alignment letter until you can
place the transducer on the transom correctly.
3. Assembling the transducer.
A. One-piece bracket: Once you determine the correct position for
the ratchets, assemble the transducer as shown in the following fig-
ure. Don't tighten the lock nut at this time.
Bolt
Flat washer
Assemble transducer and bracket.
Metal
washer
Nut
Rubber
washers
Assemble transducer and bracket.
Bolt
14
Lock washer
Nut
Flat washer
Metal washer