Eagle Cuda 242 Portable Installation And Operation Instructions Manual page 31

Align the bracket over the cable hole with the cable slots facing away
from you and fit the cable through one of the slots. Fasten the bracket
to the dash using the three screw holes.
Power/transducer cable
Cuda 242 quick release mounting bracket. Slots in the base allow rout-
Attach the unit to the bracket by first connecting the power/transducer
and accessory cables. Then, hold the sonar unit vertically and slide it
onto the bracket from above. (The back of the unit should be touching
the front of the bracket as you lower it into position.) As you push
down, the unit will lock into place with a distinct click.
To adjust the viewing angle, pinch the ratchets with one hand, then tilt
the unit with your other hand. Release the ratchets and the unit locks
into the new position. To dismount the unit for storage, press the
ratchets and lift the unit off the bracket.
Ratchet
Screw hole
ing the cable from beneath the mount.
27
Rear
(away from viewer)
Cable slot