Appendix E - Mmsi And License Information - Eagle EVR-150 Installation And Operation Instructions Manual

Appendix E - MMSI and License Information

You must obtain a user MMSI (Marine Mobile Service Identity) and enter it into your EVR-150
in order to use the DSC functions. Contact the appropriate authorities in your country. If you
are unsure who to contact, consult your Eagle dealer.
The user MMSI is a unique nine digit number, similar to a personal telephone number. It is
used on marine transceivers that are capable of using DSC (Digital Select Calling).
Depending upon your location, you may need a radio station license for the EVR-150. You
may also need an individual operator's license.
Eagle recommends that you check the requirements of your national radio
communications authorities before operating DSC functions.
FCC Compliance
This device complies with Part 15 of the U.S. Federal Communications Commission (FCC) Rules.
Operation is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
Changes or modifications not expressly approved by the manufacturer could void the user's authority
to operate the equipment.
Note:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the factory customer service department for help.
54 EAGLE - EVR-150 Installation and Operation Instructions
....