Table of Contents
Advertisement
Procedure to remove the resistor and diode from NDC-4, 119-31, Adapter Cable:
You will notice near the end of the cable an adapter segment protected with black
heat-shrink.
To connect the EAGLE GPS unit to the EVR-150 radio, you must first remove the adapter
segment of the cable as shown in the following figures.
Remove the adapter segment at the end of your data cable as shown at left. Snip off the end
of the cable protected by the black heat-shrink. At right, we have used clear heat-shrink for
clarity, so you can see the diode and resistor protected within. Remove this portion of the
cable.
After you've removed the adapter segment, use wire pliers to expose the ends of the five
remaining wires in the cable. Cut off the black, blue and white wires, then seal their ends
with heatshrink.
Make the wire connections to the EVR-150 GPS/COM cable as follows:
•
Strip about 1/4-inch (6.35 mm) of insulation from the Yellow wire and connect to the
Yellow wire on the EVR-150 GPS/COM cable.
•
Connect the Bare Stranded Drain wire to the Green wire on the EVR-150 GPS/COM cable.
EAGLE GPS unit
NDC-4, 119-31,
Adapter Cable
Ensure each connection is secure and weather proof.
EAGLE - EVR-150 Installation and Operation Instructions
EVR-150
GPS/COM
Cable
53
Advertisement
Table of Contents
