Time Display Options (Time Display); Position Display Options (Ll Display); Course And Speed Display Options (Cog/Sog) - Eagle EVR-150 Installation And Operation Instructions Manual

1. Select GPS/DATA, then SETTING.
2. Select TIME FORMAT.
3. Select 12 Hr or 24 Hr as desired. In this example, 12 hour format has been selected and so
the LCD shows the AM or PM suffix.

2-5-4 Time Display Options (TIME DISPLAY)

If you have entered the time manually as described in the previous sections, the time is always
shown on the screen with the prefix M.
However, if the vessel position is being updated through a GPS navigation receiver, you can
switch the time display on the screen ON or OFF as follows:
GPS/DATA
TIME OFFSET
TIME FORMAT
>TIME DISPLY
If the time display is set ON, course and speed data are not displayed on the LCD (see section
2-5-6).

2-5-5 Position Display Options (LL display)

If you have entered the vessel position manually as described in the previous section, the vessel
is always shown on the screen with the suffix M.
However, if the time is being updated through a GPS navigation receiver, you can switch the
vessel position display on the screen on or off as follows:
GPS/DATA
TIME FORMAT
TIME DISPLY
>LL DISPLAY
2-5-6 Course & Speed Display Options (COG/SOG)
Use this option to display course over ground (COG) and speed over ground (SOG) data on
the screen.
GPS/DATA
TIME DISPLY
LL DISPLY
>COG/SOG
If COG/SOG is set ON (on), the time is not displayed on the screen (see section 2-5-4).
24
TIME DISPLY
ON
>OFF
LL DISPLAY
ON
>OFF
COG/SOG
>ON
OFF
EAGLE - EVR-150 Installation and Operation Instructions
1. Select GPS/DATA, then SETTING.
2. Select TIME DISPLAY.
3. Select ON (on) or OFF (off ) as desired.
In this example, OFF has been selected
and so the screen no longer shows the
time.
1. Select GPS/DATA, then SETTING.
2. Select LL DISPLAY.
3. Select ON (on) or OFF (off ) as desired.
In this example, OFF has been selected
and the screen no longer shows the
vessel position.
1. Select GPS/DATA, then SETTING.
2. Select COG/SOG.
3. Select ON (on) or OFF (off ) as desired.
In this example, ON has been selected
and so the screen shows the bearing
and speed.
position