Eagle EVR-150 Installation And Operation Instructions Manual page 17

H/L Transmission Power. High (HI) 25W or Low (LO) 1W. Press to toggle between high
or low transmission power for the entire channel bank. The HI or LO selection is
shown on the LCD.
Some channels allow only low power transmissions. Error beeps will sound if the
power transmission setting is incorrect.
Some channels allow only low power transmissions initially, but can be changed to
high power by holding down H/L and PTT at the same time. See Appendix C for a
complete listing of channel charts.
Three Favourite Channels. Also on the microphone. Press to toggle between
3CH
your favourite channels. The CH1, CH2, or CH3 symbol appears on the LCD to show
which favourite channel is selected.
To scan only one of your favourite channels, press 3CH then immediately press
and release SCAN. If you want to scan all three favourite channels, press 3CH then
immediately press and hold SCAN.
To add a favourite channel for the first time, select that channel then hold 3CH
to store it in the CH1 location. Repeat the procedure to store two more favourite
channels in the CH2 and CH3 locations respectively.
If you try and add another favourite channel it will overwrite the existing CH3. CH1
and CH2 remain unless you delete them.
To delete a favourite channel, select that channel then hold down 3CH until the
CH1, CH2 or CH3 symbol disappears off the LCD.
UIC Channel Bank. Press to toggle between USA, International or Canadian channel
banks. The selected channel bank is displayed on the LCD along with the last used
channel. All the channel charts are shown in Appendix C.
SCAN Scan. Press to scan between your current channel and the priority channel in DUAL
or TRI WATCH mode. The weather channel is also scanned if the USA channel bank is
selected and the weather alert mode (ALT) is ON.
Hold down SCAN to enter ALL SCAN mode where the priority channel is checked
every 1.5 seconds.
When a signal is received, scanning stops at that channel and BUSY appears on the
screen. If the signal ceases for more than 5 seconds, the scan restarts.
Press ENT to temporarily skip over (lock out) an "always busy" channel when in ALL
SCAN mode and resume the scan. An X is shown on the screen to designate a
skipped channel. Note that it is not possible to skip over the priority channel.
Press SCAN to stop at the current channel.
Channel Select. Also on the microphone. The current channel is shown on the
+ CH -
screen in BIG digits with an appropriate designator suffix A or B in small letters
below the channel number.
Press + or - to step through the available channels one at a time, or hold down
to scroll rapidly through all the available channels. See Appendix C for a listing of
channel charts.
EAGLE - EVR-150 Installation and Operation Instructions 17