Table of Contents
Advertisement
4. Press ENT (repeatedly if necessary) to display the YES/NO confirmation.
5. Press ENT to confirm the new channel name tag or the deletion, then press ESC to return
to the menu.
3-3 RING & BEEP Volume (RING VOLUME) and (BEEP VOLUME)
Set the volume level of the incoming signal beeps (RING VOLUME) and/or the error and
warning beeps (BEEP VOLUME) to HIGH (high) or LOW (low) as follows:
RADIO SETUP
CH NAME
>RING VOLUME
BEEP VOLUME
1. Select RADIO SETUP, then RING VOLUME or BEEP VOLUME as appropriate.
2. Select a HIGH or LOW volume. (It is possible to turn the beeps off completely by selecting
BEEP VOLUME then OFF.)
3. Press ENT to enable the new volume setting and return to the menu.
3-4 Internal Speaker Connections (INT SPEAKER)
Switch the radio's internal speaker ON (on) or OFF (off ). The external speaker is always ON (on)
if a speaker is plugged into the external speaker jack.
RADIO SETUP
RING VOLUME
BEEP VOLUME
>INT SPEAKER
3-5 Set the Priority Channel (WATCH MODE)
An EVR-150 operating on USA or Canadian channel banks, you can set the priority channel to
cover both CH16 and CH09 as well as the working channel, as follows:
RADIO SETUP
BEEP VOLUME
INT SPEAKER
>WATCH MODE
RING VOLUME
>HIGH
LOW
INT SPEAKER
>ON
OFF
WATCH MODE
>ONLY 16CH
16CH+9CH
EAGLE - EVR-150 Installation and Operation Instructions
BEEP VOLUME
>HIGH
LOW
OFF
1. Select
RADIO
SPEAKER.
2. Select ON (on) or OFF (off ) then press
ENT to enable the setting and return
to the menu.
1. Select RADIO SETUP, then WATCH
MODE.
2. Select ONLY 16CH for dual watch
mode, or 16CH+9CH for tri watch
mode.
SETUP,
then
INT
27
Advertisement
Table of Contents
