Appendix D - Wiring For Eagle Gps Models - Eagle EVR-150 Installation And Operation Instructions Manual

Appendix D - Wiring for EAGLE GPS models

Wiring for Eagle GPS models with NDC-4, 119-31, Adapter Cable:
FishElite 480
FishElite 502c iGPS
FishElite 642c iGPS
SeaCharter 502c DF iGPS
SeaCharter 642c DF iGPS
IntelliMap 500c
IntelliMap 640c
Cuda 250 S/Map
1. Remove diode and resistor (installed at end of cable) – refer to next page for instructions
2. Connect wires as follows:
EVR-150
Yellow (NMEA IN +)
Green (NMEA IN -)
3. Configure the COM port on the connected EAGLE GPS unit. Refer to the documentation
supplied with your EAGLE GPS model.
Wiring to Eagle GPS model with PC21X, 99-56, Power Cable:
SeaCharter 480DF
1. Connect wires as follows:
EVR-150
Yellow (NMEA IN +)
Green (NMEA IN -)
2. Configure the COM port on the connected EAGLE GPS unit. Refer to the documentation
supplied with your EAGLE GPS model.
52
FishElite 500c
FishElite 640c
SeaCharter 500c DF
SeaCharter 640c DF
IntelliMap 480
IntelliMap 502c iGPS
IntelliMap 642c iGPS
Eagle GPS Unit
Yellow (NMEA OUT)
Drain – Bare Stranded (Ground)
Eagle GPS Unit
Yellow (NMEA OUT)
Drain – Bare Stranded (Ground)
EAGLE - EVR-150 Installation and Operation Instructions