Checking The Image Before Forwarding - Sharp MX-3111U Operation Manual

CHECKING THE IMAGE BEFORE
FORWARDING
When "Received Data Image Check Setting" is enabled in the system settings (administrator), you can select the
received data from the list and forward it to the addresses recorded in the address book. When this function is enabled,
follow the steps below to forward the received image.
* The factory default setting is disabled.
Depending on the size of the received data, part of the image in the image check screen on the touch panel may not appear.
The memory has received data.
Check the data?
1
Received Data List
Thumbnail
AAA AAA
BBB BBB
2 0123456789
BBB BBB 9876543210
0612345678 BBB BBB
CCC CCC
Image Check Forward
(2)
To
5 10 15
AAA AAA
Address Review
CCC CCC
EEE EEE
3
GGG GGG
III III
Freq.
Sort Address
No Yes
(1)
Back
Select All
04/04/2010 10:28 Not checked
04/04/2010 10:14 Checked
04/04/2010 10:12 Not checked
04/04/2010 10:08 Checked
10:00
04/04/2010 Not checked
04/04/2010 10:00 Checked
Delete Print
Cc
BBB BBB
DDD DDD
FFF FFF
HHH HHH
JJJ JJJ
ABCD EFGH IJKL MNOP QRSTU VWXYZ
Start forward.
When an image is received, a
confirmation prompt will appear. Touch
the [Yes] key.
If this message appears while you are configuring settings of
any type and you touch the [Yes] key, the settings that you are
configuring will be canceled. If this message appears in another
mode, you will return to the base screen of image send mode
after checking the image.
Select the received image
(1) Touch the key of the received image that
you want to check.
Multiple received images can be checked.
1
(2) Touch the [Forward] key.
5
• To show thumbnails of the received images, touch the
[Thumbnail] key.
• The receieved image can be checked by touching the
[Image Check] key.
This function requires the hard disk drive.
☞
IMAGE CHECK SCREEN
Touch the Forward Destination from the
address book to select it.
1
Multiple forwarding addresses can be checked.
2
etc.
5-116
SCANNER/INTERNET FAX
(Page 5-118)
Contents