Eagle FishEasy 250 DS Installation And Operation Instructions Manual page 27

In saltwater environments we recommend you connect the power
cable to the auxiliary power switch included in most boat designs.
If that results in electrical interference, or if such a switch is not
available, we recommend connecting direct to the battery and in-
stalling an inline switch. This will let you shut off power to the
power cable when the unit is not in use. When you are not using
the unit, you should always shut off power to the power cable, es-
pecially when the power cable is disconnected from the unit.
To unit
Power and transducer connections for sonar
WARNING:
Do not use this product without a 3-amp fuse wired into
the power cable! Failure to use a 3-amp fuse will void
your warranty. This product must be independently
fused with the enclosed 3-amp fuse (or equivalent), even
if you connect to a fused accessory or power buss. If a
malfunction happens inside the unit, extensive damage
can occur if the enclosed fuse is not used. As with all elec-
trical devices this unit could be damaged to a point that
it is unrepairable and could even cause harm to the user
when not properly fused.
Black wire
units (direct battery connection shown).
Optional power off switch
for saltwater installations
12 volt
battery
23
Red wire with
3 amp fuse