Table of Contents
Advertisement
Shoot-thru-hull Installation
1. Make sure the area is clean, dry and free of oil or grease, then sand
both the inside surface of the hull and the face of the transducer with
100 grit sandpaper.
The sanded hull area should be about 1-1/2 times the diameter of the
transducer. The surface of the hull must be flat so the entire trans-
ducer face is in contact with the hull prior to bonding. After sanding,
clean the hull and transducer with rubbing alcohol to remove any
sanding debris.
Orient the Skimmer
with the nose facing
the bow of the boat.
WARNING:
Use only the epoxy available from LEI. It has been for-
mulated to work with these installation procedures.
Other epoxy types may be too thin or may not cure to
the right consistency for optimum transducer perform-
ance.
2. The epoxy consists of the epoxy itself and a hardener. Remove the
two compounds from the package and place them on the paper plate.
Sand this surface
To bow
Epoxy transducer to hull.
Spread epoxy here
21
Hide quick links:
Advertisement
Table of Contents
