Philips HF3485/60 User Manual page 7

EnglisH
10
specify stock number 004-000-00345-4 when ordering copies. This equipment has been
type-tested and found to comply with the specifications in Subpart J of Part 15 of FCC Rules.
- This appliance meets the requirements of the low voltage directive 2006/95/EC and the EMC
directive 2004/108/EC.int
introduction
Congratulations on your purchase and welcome to Philips! To fully benefit from the support that
Philips offers, register your product at www.philips.com/welcome.
The Philips Wake-up Light helps you wake up more pleasantly. The light intensity of the lamp
gradually increases to the set level in the 30 minutes before the set wake-up time. The light gently
prepares your body for waking up at the programmed time. To make waking up an even more
pleasant experience, you can use natural wake-up sounds, the FM radio or even downloaded sounds
or your own music from a USB stick.
The effects of the Wake-up light
The Philips Wake-up Light gently prepares your body for waking up during the last half hour of
sleep. In the early morning hours our eyes are more sensitive to light than when we are awake.
During that period the relatively low light levels of a simulated natural sunrise prepare our body for
waking up and getting alert. People who use the Wake-up Light wake up more easily, have a better
overall mood in the morning and feel more energetic. Because the sensitivity to light differs per
person, you can set the light intensity of your Wake-up Light to a level that matches your light
sensitivity for an optimal start of the day.
For more information about the Wake-up Light, see www.philips.com.
general description (Fig. 1)
A Top cover with vents
B Lamp housing
C Power cord
D Antenna
E Display
1 Clock time/alarm time
2
Light intensity symbol
3
Radio symbol
4 'Bird' sound symbol
5 'Yoga' sound symbol
6 'Cowbell' sound symbol
7
'Forest' sound symbol
8
'USB stick' symbol
9 Radio frequency symbol
10 Volume level symbol
11 Display brightness symbol
12 Dusk simulation symbol
13 Alarm sound symbol
14 Alarm 2 symbol
15 Alarm 1 symbol
16 Clock time symbol
F Menu '-' button
g MENU button
H SELECT button (also FM presets selection)
i Menu '+' button
J Control lever with 'alarm off ', 'alarm 1' and 'alarm 2' positions
K USB socket
l Buttons on the side of the appliance
1
Light intensity increase button
2
Lamp on/off button
3 Light intensity decrease button
4 Volume increase button
5 Radio on/off button
6
Volume decrease button
Preparing for use
Before first use
1 Place the Wake-up Light 16-20in/40-50cm from your head, for example on a bedside table.
2 Put the plug in the wall outlet.
- The hour indication on the display starts flashing to indicate that you have to set the clock
time (Fig. 6).
setting the clock time
You cannot use the Wake-up Light until you have set the clock time.
1 When the hour indication on the display flashes, press the menu + or – button to set the
hour.
Note: You can only do this when you are in the set clock menu and when the hour indication flashes. If
this is not the case, press the MENU button, use the menu + or – button to select the set clock menu
and press the SELECT button to confirm. You are now in the set clock menu.
2 Press the SELECT button to confirm.
The minute indication starts flashing (Fig. 7).
,
3 Press the menu + or – button to set the minutes.
4 Press the SELECT button to confirm.
The appliance leaves the menu and the display shows the set clock time.
,
The appliance is now ready for use.
Note: Every time you remove the plug from the wall outlet for more than approximately 15 minutes, you
have to set the clock time again. To change the set clock time when the plug is still in the wall outlet, see
section 'Menu functions' in chapter 'Using the appliance'.
Using the appliance
Use this appliance for its intended household use as described in this manual.
Menu functions
Below find a description of all functions that can be set in the menu. These functions appear in the
menu in the following order:
- Clock time
- Alarm time 1
- Alarm time 2
- Alarm sound
- Dusk simulation
- Display brightness
You can set the menu functions in the following way:
1 Press the MENU button to enter the menu (Fig. 8).
EnglisH
11