Configuration2 Menu; Information Osd; Factory Reset - Philips BDL4245E/27 User Manual

BDL3245E / BDL4245E / BDL4645E
Language
Select the language used in the OSD menu.
The options are: { } / {
{ } / { } / { } / {
Panel saving
Choose to enable the panel saving functions to reduce the risk of the
"image persistence".
• {Cooling Fan} - Select {On} to turn on the cooling fan all the
time. Select {Auto} to turn on/off the cooling fan according to the
monitor temperature.
NOTE: T he speed of the cooling fan is pre-set to {low}, {mid}, or
{high} speed each at 50°C, 58°C, or 63°C respectively. The
monitor will automatically shut down by reaching a preset
critical temperature of 82°C.
• {Brightness} - Select {On} and the brightness of the image will be
reduced to an appropriate level, and the Brightness setting in the
Picture menu will become unavailable.
• {Pixel shift} - Select the time interval ({Auto} / {10 ~ 900} Seconds
/ {Off}) for the monitor to slightly expand the image size and shift
the position of pixels in four directions (up, down, left, or right).
Network control port
Select the nectwork control port.
The options are: {RJ-45} / {RS-232}.
Network settings
Assign {IP}, {Subnet Mask}, and {Default gateway} for the display.
Network settings
Network host name
DHCP
IP address
Subnet mask
Default gateway
Login user name
Login password
• DHCP - Choose to enable or disable the DHCP function. If enabled,
the display will be assigned IP address, Subnet mask and Default
gateway automatically. If disabled, you will be prompted to enter the
following value manually. Finally, press [SET] button to store and save
the chosen values.
• IP address
• Subnet mask
• Default gateway
• Login user name
• Login password
Configuration reset
Reset all settings in the Configuration1 menu.

Factory reset

Reset all the settings in the OSD menus of {Picture}, {Screen}, {Audio},
{PIP}, {Configuration1}, {Configuration2}, and {Advanced option}.
Press [ ] or [ ] button to select [Reset], and then press [SET] button
to do the reset.
} / { } / { } / {
}.
0 0 0 0 0 0
Disable
0 - 0 - 0 - 0
0 - 0 - 0 - 0
0 - 0 - 0 - 0
a d m i n
0 0 0 0
[ SET ]
change [SET] in STORE
Factory reset
} /
Cancel

4.2.6. Configuration2 menu

Picture
Screen
Audio
PIP
Configuration1
Configuration2
Advanced option
OSD turn off
Set the period of time the OSD menu stays on the screen.
The options are: {5 ~ 120} seconds.

Information OSD

Set the period of time the information OSD displayed on the upper
right corner of the screen. The information OSD will display when input
signal is changed.
The information OSD will remain on the screen with {Off} selection.
The options are: {1 ~ 60} seconds.
Off Timer
Set the monitor to turn itself off to standby mode within an amount of
time specified.
The options are: {Off, 1 ~ 24} hours.
NOTE: W hen the "Off timer" is activated, the "Schedule" settings will
be disabled.
OSD H-position
Adjust the horizontal position of the OSD menu.
OSD V-position
Adjust the vertical position of the OSD menu.
Monitor Information
Displays the information about your monitor, including model number,
serial number, operating hours and software version.
Monitor information
18
Reset
OSD turn off
Information OSD
Off timer
OSD H-position
OSD V-position
Monitor information
Model name: BDL3245E
Serial:
Operation Hours:
0 H 3M
Sw Version:
VER 0.203