Inserting The Batteries In The Remote Control; Handling The Remote Control; Operating Range Of The Remote Control - Philips BDL4245E/27 User Manual

BDL3245E / BDL4245E / BDL4645E

2.3.2. Inserting the batteries in the remote control

The remote control is powered by two 1.5V AAA batteries.
To install or replace batteries:
1. Press and then slide the cover to open it.
2. Align the batteries according to the (+) and (–) indications inside the
battery compartment.
3. Replace the cover.
Caution:
An incorrect use of batteries can result in leaks or bursting. Be careful especially about the following points.
• Place "AAA" batteries matching the (+) and (–) signs on each battery to the (+) and (–) signs of the battery compartment.
• Do not mix battery types.
• Do not combine new batteries with used ones. It causes shorter life or leakage of batteries.
• Remove the dead batteries immediately to prevent it from liquid leaking in the battery compartment. Don't touch exposed battery acid, it cause
damage to your skin.
NOTE: I f you do not intend to use the remote control for a long period, remove the batteries.

2.3.3. Handling the remote control

• Do not subject to strong shock.
• Do not allow water or other liquid to splash the remote control. If the remote control gets wet, wipe it dry immediately.
• Avoid exposure to heat and steam.
• Other than to install the batteries, do not open the remote control.

2.3.4. Operating range of the remote control

Point the top of the remote control toward the monitor's remote control
sensor when pressing a button.
Use the remote control within a distance of less than 10m/33ft away from
the monitor's sensor, and a horizontal and vertical angle of less than 30
degrees.
NOTE: T he remote control may not function properly when the remote
control sensor on the monitor is under direct sunlight or strong
illumination, or when there is an obstacle in the path of signal
transmission.
8
30 30
POWER
VIDEO AUDIO
SMART SOURCE SOURCE
PIP
ON/OFF INPUT CHANGE
CONTRAST BRIGHTNESS
DISPLAY MENU
SET
AUTO EXIT
ADJUST
VOL UP
MUTE
VOL DOWN