Basic Functions
M I C R O S Y S T E M M C M 1 9 6 D
IMPORTANT:
Before you operate the system, complete
the preparation procedures.
Plug and Play
Plug and Play allows you to store all available
radio stations automatically.
First time setup/power up
1
When you turn on the main supply, "AUTO
INSTALL - PRESS PLAY" is displayed.
2
PressÉ Å on the system to start installation.
➜
"PLUG AND PLAY" .... "INSTALL" is
displayed, followed by "TUNER" and "AUTO".
➜
starts flashing.
PROG
➜
The system will automatically store the radio
stations with sufficient signal strength, starting
from FM, then followed by AM band.
➜
When all the available radio stations are
stored or the memory for 40 presets are used,
the last preset radio station will be played.
To reinstall Plug and Play
1
In standby mode, press and holdÉ Å on the
system until "AUTO INSTALL - PRESS PLAY"
is displayed.
2
PressÉ Å again to start installation.
➜
All previously stored radio stations will be
replaced.
14
(for tuner installlation)
To exit without storing the Plug and Play
●
PressÇon the system.
➜
If you do not complete the Plug and Play
installation, the function will be restarted when
you next turn on the main supply again.
Notes:
– If no stereo frequency is detected during Plug
and Play, "CHECK ANTENNA" will be displayed.
– During Plug and Play, if no button is pressed
within 15 seconds, the system will exit Plug and
Play mode.